User manual

Operator's Manual
WSta-OM-E RevA
65
 The USB connector on the Front Panel is also used
for USB memory sticks. USB memory sticks are plug-
and-play supported and no special setting is needed
for their use.
o Make selections as desired and press the Done (to commit)
or Cancel option button and the main Util menu is shown.
 Output Setup - Press this option button and an additional menu is
shown.
Use these additional output controls for the following:
o Load/HighZ - Use this option button to select either Load or
HighZ for your waveform output.
o Normal/Invert - Use this option button to select either
Normal or Invert for your waveform output.
o Sync - Press this option button and an additional menu is
provided where you can turn the State of your
synchronization On/Off and use the Channel option button
to send the synchronized signal to CH1 or CH2.
Make selections as desired and press the Done (to commit)
or Cancel option button and the main Util menu is shown.
All standard output functions (except DC and Noise) have a
corresponding Sync signal sent through the Sync Out
connector on the Back Panel (on page 14). This can be
disabled on certain settings as follows: