User manual

WaveStation

WSta-OM-E RevA

This section covers sweep waveform creation and making specific

adjustment/selection parameter choices - all of which vary based on the

specific function and carrier waveform selection made.

While details around creating waveforms and adjusting specific

parameters (which vary based on the specific sweep waveform) are

covered here, the following section covers some menu control

considerations.

For more information on getting to this point, see Navigating Interfaces,

Adjusting Parameters, and Making Selections (on page 16).

Common Sweep Waveform Menu Controls and

Considerations

 After pressing the Sweep button on the Front Panel (on page 13),

select the desired modulated waveform type using the Display

Menu Operation buttons. The waveform is shown on the

Waveform Display.

 At this point, the Display Menu Operation buttons are used to

select applicable parameters and make adjustments as desired.

A good portion of the waveform operation buttons control two

separate parameters. Operation buttons controlling two

parameters have additional, lighter shaded function labels on

them; press the button once to adjust the top control parameter;

twice to adjust the bottom one. Make adjustments using the

Digital Input Front Panel Controls (on page 27).

 Second operation button press parameters are shown in reverse

color on the waveform detail dialog to provide a visual indication

as to which parameter is being adjusted in the detail dialog.