User manual

Operator's Manual
WSta-OM-E RevA
33
% of High Level
Frequency
20 to 80%
< 10 MHz
40 to 60%
From 10 MHz to 20 MHz
50%
> 20 MHz
PLEASE NOTE THE FOLLOWING:
Press an adjacent Operation button to select a desired Unit (unit
interval) for your entry.
Provide your desired Duty Cycle amount using the Digital Input
Front Panel Controls (on page 27).
Creating a Ramp Wave
When first pressing this waveform button on the Front Panel, the
WaveStation shows the Ramp Operation menu and corresponding
Display and Detail dialogs.
Press adjacent Operation buttons and use the Digital Input Front Panel
Controls (on page 27) to make specific adjustment/selection parameter
choices. For more information on getting to this point, see Navigating
Interfaces, Adjusting Parameters, and Making Selections (on page 16).
Note: Ramp Operation menu selections and parameters include
Frequency/Period, Amplitude/HLevel, Offset/LLevel, Phase/EqPhase,
and Symmetry. The parameters for Frequency/Period,
Amplitude/HLevel, Offset/LLevel, Phase/EqPhase are carried out the
same way as done when Creating a Sine Wave (on page 28).
Setting the Symmetry is done as follows: