User manual

WaveAce Remote Control
10
920836 Rev A
Commands and Queries by Subsystem
Acquisition - Controlling Waveform Captures
Short Form
Long Form
What the Command/Query Does
*TRG
*TRG
Executes an ARM command.
ARM
ARM_ACQUISITION
Changes acquisition state from stopped to single.
ASET
AUTO_SETUP
Adjusts vertical, timebase and trigger parameters.
ATTN
ATTENUATION
Selects the vertical attenuation factor of the probe.
BWL
BANDWIDTH_LIMIT
Enables/disables bandwidth-limiting low-pass filter.
CPL
COUPLING
Selects the specified input channel's coupling mode.
FRTR
FORCE_TRIGGER
Forces the instrument to make one acquisition.
ILVD
INTERLEAVED
Enables/disables Random Interleaved Sampling (RIS).
OFST
OFFSET
Allows output channel vertical offset adjustment.
PDET
PEAK_DETECT
Enables or disables built-in peak detection function.
STOP
STOP
Immediately stops signal acquisition.
TDIV
TIME_DIV
Modifies the timebase setting.
TRCP
TRIG_COUPLING
Sets the coupling mode of the specified trigger source.
TRDL
TRIG_DELAY
Sets the time at which the trigger is to occur.
TRLV
TRIG_LEVEL
Adjusts the trigger level of the specified trigger source.
TRMD
TRIG_MODE
Specifies the trigger mode.
TRSE
TRIG_SELECT
Selects the condition that will trigger acquisition.
TRSL
TRIG_SLOPE
Sets the trigger slope of the specified trigger source.
VDIV
VOLT_DIV
Sets the vertical sensitivity.
WAIT
WAIT
Prevents new analysis until current is completed.
Cursor - Performing Measurements
Short Form
Long Form
What the Command/Query Does
CRMS
CURSOR_MEASURE
Specifies the type of cursor/parameter measurement.
CRST
CURSOR_SET
Allows positioning of any cursor.
CRVA?
CURSOR_VALUE?
Returns trace values measured by specified cursors.
PACU
PARAMETER_CUSTOM
Controls parameters with customizable qualifiers.
PAVA?
PARAMETER_VALUE?
Returns current parameter, mask test values.