Information

Teledyne LeCroy WaveAce Integration with LogicStudio page | 8 of 10
Thus, in the case of the SPI signal, the nominal D8 channel was renamed and reconfigured for SPI decode in the
manner shown in Figure 7.
Figure 7: To ready the LogicStudio software for SPI decode, channel D8 was redesignated for SPI Decode as shown in the Type:
field. The channel was renamed “SPI,” and the Data, Clock, and Chip Select signals were indicated as being on lines D8, D9, and
D10 of the LogicStudio module, respectively
All channels can also be brought up simultaneously for reconfiguration/renaming by using the Setup: options in
the GUI shown in Figure 8. The resulting screen is shown in Figure 9.
Figure 8: All channel configurations can be displayed at once by clicking the Signals button
in the Setup: area of the LogicStudio GUI
Figure 9: Shown are the configuration dialog boxes for all channels