Information

Teledyne LeCroy WaveAce Integration with LogicStudio page | 6 of 10
After clicking the Next button seen in Figure 3, the Device Wizard provides a diagram of the connections outlined
above, shown in Figure 4.
Figure 4: After confirming that the hardware is connected, the Device Wizard provides a
diagram of all interconnections required for mixed-signal operation
Clicking Next again brings up confirmation that the LogicStudio and WaveAce “have been successfully connected
in MSO mode.”
Displaying Signals in LogicStudio software
With all hardware connected and software running, the next step is to configure the newly-configured MSO to
display the desired signals. Figure 5 shows the initial LogicStudio screen.