User manual

WAVESURFER MXS-B OSCILLOSCOPE
WSMXs-B-GSM-E Rev A 12
WARNING
The WARNING sign indicates a potential hazard. It calls attention to a
procedure, practice or condition which, if not followed, could possibly
cause bodily injury or death. If a WARNING is indicated, do not
proceed until its conditions are fully understood and met.
CAT I
Installation (Overvoltage) Category rating per EN 61010-1 safety
standard and is applicable for the oscilloscope front panel measuring
terminals. CAT I rated terminals must only be connected to source
circuits in which measures are taken to limit transient voltages to an
appropriately low level.
Operating Environment
The instrument is intended for indoor
use and should be operated in a clean,
dry environment. Make sure the
operating environment is maintained
within the following parameters prior
to use:
 Temperature: 5 to 40 °C
 Humidity: Maximum relative
humidity 80% for temperatures up
to 31 °C decreasing linearly to 50%
relative humidity at 40 °C.
 Altitude: Up to 2,000 m
Note: Direct sunlight, radiators, and
other heat sources should be taken
into account when assessing the
ambient temperature.
WARNING
The oscilloscope must not be operated in
explosive, dusty, or wet/damp
atmospheres.
The design of the instrument has been
verified to conform to EN 61010-1
safety standard per the following
limits:
 Installation (Overvoltage)
Categories II (Mains Supply
Connector) & I (Measuring
Terminals)
 Pollution Degree 2
 Protection Class I
CAUTION
Protect the DSO’s display touch screen
from excessive impacts.
CAUTION
Do not exceed the maximum specified
front panel terminal (CH1, CH2, CH3, CH4,
EXT) voltage levels. Refer to Specifications
for more details.