User manual

3.2.1.3 Deleting a Template
1.
After opening the Set Initial Decoder Parameters window click the Delete button in the toolbar.
The system displays the Template Manager dialog with a list of saved templates.
2. Select (click on and highlight) the template marked for deletion and click the Delete button.
The system removes the selected template from the list of saved templates.
3. Click the OK button to complete the deletion process and close the Delete dialog.
4. Click the OK button on the Set Initial Decoder Parameters window to apply the deletion and close
the dialog.
3.2.2 Selecting A2DP Decoder Parameters
Decoding SBC frames in the A2DP decoder can be slow if the analyzer decodes all the parts (the header, the scale
factor and the audio samples) of the frame. You can increase the decoding speed by decoding only the header
fields and disregarding other parts. You can select the detail-level of decoding using the Set Initial Decoder
Parameters window.
Note: By default the decoder decodes only the header fields of the frame.
1. Select Set Initial Decoder Parameters from the Options menu on the Control window or the Frame
Display window.
2. Click on the A2DP tab.
3. Choose the desired decoding method.
Figure 3.12 - A2DP Decoder Settings
4. Follow steps to save the template changes or to save a new template.
5. Click the OK button to apply the selection and exit the Set Initial Decoder Parameters window.
3.2.3 L2CAP Decoder Parameters
3.2.3.1 About L2CAP Decoder Parameters
Each entry in the Set Initial Decoder Parameters dialog takes effect from the beginning of the capture onward or
until redefined in the Set Subsequent Decoder Parameters dialog.
TELEDYNE LECROY Chapter 3 Configuration Settings
24 Frontline BPA low energy Hardware & Software User Manual