User manual

Note: The tabs displayed on the Find dialog depend on the product you are running and the
content of the capture file you are viewing.
Figure 5.9 - Find Signal tab.
You will choose one qualifier—Searching for event where, then choose one or more control signals
Control Signals
The section with the check boxes allows you to specify which control signals the analyzer should pay attention to
when doing the search. The analyzer pays attention to any control signal with a check mark.
l Click on a box to place a check mark next to a control signal
l Click again to uncheck the box
l By default, the analyzer searches all control signals, which means all boxes start out checked.
For example, if you are only interested in finding changes in RTS and CTS, you would check those two boxes
and uncheck all the other boxes. This tells the analyzer to look only at the RTS and CTS lines when running the
search. The other signals are ignored.
The control signals types include:
l USB - Pin 1
l USB - Pin 2
l USB - Pin 3
l USB - Pin 4
Chapter 5 Navigating and Searching the Data TELEDYNE LECROY
Frontline BPA low energy Hardware & Software User Manual 169