User manual

Selection Description
Reset Resets the Coexistence View window to its default settings.
Exit Closes the Coexistence View window.
Table 4.5 - Coexistence View File Menu Selections
Selection Description
Show Packet
Number
When checked, the packet number shows below the packet in the Viewport.
Show Packet
Type
When checked, the packet type shows below the packet in the Viewport.
Show Packet
Subtype
When checked, the packet subtype shows below the packet in the Viewport, if applicable.
Hide Packet
Text
When checked, hides any text shown below the packet in the Viewport. Applies the text
shown by the Show Packet Number,
Show Packet Type
, and
Show Packet Subtype
menu selections.
Auto Hide
Packet Text
When
Duration >
31.25 ms
.
When checked, automatically hides any text shown below the packet in the Viewport
when the Viewport duration exceeds 31.25 ms. Applies the text shown by the Show
Packet Number,
Show Packet Type
, and
Show Packet Subtype
menu selections.
The Viewport duration is shown at the bottom of the Viewport. This selection reduces
display clutter when viewing a larger timeline section.
Increase Auto
Hide Packet
Count from
4,000 to 20,000
(May Be Slow)
When not checked, the default, the packets in the viewport are hidden if the number of
visible packets exceeds 4,000.
When checked, the default count increased from 4,000 to 20,000 packets before the
packets are hidden. Choosing this selection may slow down the displaying of the
packets.
The following three selections are mutually exclusive.
Use All
Packets for
Throughput
Indicators
When checked, all captured packets are used for average throughput calculations and
all packets in the last one second of the capture session are used for the 1 sec
throughput. See
on page 106
for more information. Performs the same function as the
throughput indicator
All
radio button.
Use Selected
Packets for
Throughput
Indicators
When checked, the packets selected in the Viewport are used for average throughput
calculations, and selected packets in the one second before the last selected packet are
used for the 1 sec throughput. See
on page 106
for more information. Performs the
same function as the throughput indicator
Selected
radio button.
Use Viewport
Packets for
Throughput
Indicators
When checked, all packets appearing in the Viewport are used for average throughput
calculations, and all packets in the one second before the last packet in the Viewport are
used for the 1 sec throughput. See
on page 106
for more information. Performs the
same function as the throughput indicator
Viewport
radio button.
Table 4.6 - Coexistence View Format Menu Selections
TELEDYNE LECROY Chapter 4 Capturing and Analyzing Data
98 Frontline BPA low energy Hardware & Software User Manual