User manual

Operator’s Manual

922244-00 Rev A

The Waveform Sequencer - Analog

Creating Standard and Advanced Waveforms

Creating a Standard Waveform

Create a new waveform in the Waveform Sequencer using the following

steps.

 Press the Add Standard Waveform button.

 The Waveform Standard Editor dialog box is shown.

 Provide a Name for your waveform.

 Use the Type drop-down and select DC Level, Sine, Increase Ramp,

Sawtooth, Rectangle, or Triangle.

 Use fields on the Timing section to set Length, Frequency, and Cycle

parameters.

 Fields on the Parameters section can be used to set Amplitude,

Offset, Phase, Maximum and Minimum Voltage levels

 Click the OK button to create the waveform and add it to the

project.