User manual

ArbStudio
148
922244-00 Rev A
3. The Waveform Standard Editor dialog box is shown.
In the fields on the Editor, select a Sine waveform Type, 1 MHz
Frequency, 250 Samples, and 1 Volt Amplitude.
Click OK.
4. On the Project Waveforms tab under the Waveform Sequencer,
select the waveform you just created and click the Add Waveform
button (adding your new waveform to the Sequencer).
5. Double-click Settings under Channel 1 (Arbitrary) on the Device
Control Tree. (Channel 1 can be any Analog channel you have
configured under Arbitrary Waveform Generator operating mode in
your workspace.)