User manual

ArbStudio
100
922244-00 Rev A
The following fields are available on the Clock Generator tab:
 Enable - Turns the Clock Generator Module on or off.
 Frequency - Sets the frequency (MHz) of the Clock Generator. The
output frequency depends on the Sample Rate set by the user on
the Setup Device Timing tab.
NOTE: User entries can be recalculated to allow frequency values.
 Duty Cycle - Sets the generated clock duty cycle of the clock signal.
NOTE: User entries can be recalculated to allow duty cycle values.
 Delay - It sets the delay to the synchronized signal.
NOTE: User entries can be recalculated to allow delay values.
 Strobe Operation - Lets you logically combine the Output clock with
the Extended Trigger In vector. Possible options are: NOP, OR, AND,
XOR, NOT, NOR, NAND, XNOR, FORCE LOW, and FORCE HIGH.