User manual

Operator’s Manual
923064-00 Rev A 13
Safety Compliance
EC Declaration of Conformity – Low Voltage
The probe meets intent of EC Directive 2006/95/EC for Product Safety. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement, control,
and laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for measurement,
control, and laboratory use – Part 2-030: Particular requirements for testing and measuring
circuits
EN 61010-031/A1:2008 Safety requirements for electrical equipment for measurement,
control, and laboratory use – Part 031: Safety requirements for hand-held probe assemblies
for electrical measurement and test.
 Measurement Category III (CAT III), for measurements performed in the building
installation.
 Measurement Category II (CAT II), for measurements performed on circuits directly
connected to the low-voltage installation.
 Pollution Degree 2, operating environment where normally only dry non-
conductive pollution occurs. Conductivity caused by temporary condensation
should be expected.