User Manual

inummunnump
inirAtiltftfin
tiannownenni
imulluni
illinu
m
o
lkh
Mint \
11111111111111111111111111111111)
Installation and Switching On The Appliance
• This appliance is connecting to 220-240V or 200-230V and 50 Hz. Please check
nameneplate of appliance and be sure voltage range suitable to your mains voltage.
• You can offer help from the service to install and switching on the appliance.
• Before making the connection to the power supply, ensure that the voltage on the
nameplate corresponds to the voltage of electrical system in your home.
• Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact or the plug does not match, we suggest you to call an authorised
electrician for assistance.
• The plug should be accessible after the appliance is positioned.
• Manufacturer is not responsible for failure to complete the ground
connection as described in this booklet.
• Do not place the appliance in direct sunlight.
• Do not use in open air and shall not be exposed to the rain.
• Place the refrigerator far from heat sources and in a well-ventilated position. The
refrigerator should be at least 50 cm from radiators,gas or coal stoves and 5 cm far from
electrical stoves.
• Keep the top free for at least 15 cm.
• Do not place heavy and lots of things on the appliance.
• If the appliance is installed next to another refrigerator or
freezer, observe a miminum distance of 2 cm to prevent
condensation.
• Do not put very( !)hot food or bowl on the top table.It can
damage the toptable.
• Fit the plastic wall spacers to the condenser at the back of
the refrigerator in order to prevent leaning to the wall for
good performance.
• The appliance must be stand firmly and level on the floor
Use levelling-feet to compensate for an even floor.
• The outside of the appliance and the accessories inside
should be cleaned with a solution of water and liquid soap ;
the inside of the appliance with sodium bicarbonate
dissolved in lukewarm water. After drying replace all the
accessories.
Before Switching On
• Wait after 3 hours before plugging the appliance in to the power to ensure
proper performance.
• There can be an odor when you first switch on the appliance. It will disappear
after the appliance starts to cool.
7