User's Manual

To add a port forwarding rule, perform the following steps:
Choose Firewall > Port Forwarding.
Click Add list.
Set Service.
Set Protocol.
Set Remote port range.
The port number ranges from 1 to 65535.
Set Local host.
This IP address must be different from the IP address that is set on the LAN Host Settings page,
but they must be on the same network segment.
Set Local port.
The port number ranges from 1 to 65535.
Click Submit. As shown in Figure 5-38.
Figure 5-38
Modifying Port Forwarding rule
To modify a port forwarding rule, perform the following steps:
1. Choose Firewall > Port Forwarding.
2. Choose the item to be modified, and click Edit.
3. Repeat steps 3 through7 in the previous procedure.
4. Click Submit. As shown in Figure 5-39.