User's Manual

Scan Mode
To set the lte network scan mode, perform the following steps:
choose Network>Scan mode;
You can choose full mode, a band the CPE supported
Click Submit.
Setting Frequency (Earfcn)
To set the frequency, perform the following steps:
1 Choose Network>Scan Mode.
2 In the Scan Mode area, choose Frequency Lock.
3 In the Frequency Lock area, you can choose a band, then click Add list to choose a
Earfcn Number.
4 Click Submit. As shown in Figure 5-9.
Figure 5-9
APN Management
To set and manage APN, perform the following steps:
Choose Network>APN Management.
In the APN Management area, you can set the APN.
Choose am APN number which you want to set.
In the APN Setting area you can set the APN parameters, such as enable or disable the APN, APN name,
username, password and so on.
If you want set an APN as default gateway, you should check that is enabled.
Click Submit. As shown in Figure 5-10.