User's Manual

LBS7320 Outdoor LTE TDD Base Station User’s Manual
29
It is recommended that the power cord be kept below 100m (330 feet) long distance.
The connection steps of power cable is as follows.
1. Assemble power plug.
The power plug will be installed at the end of the input direction. Connect the
live wire, neutral wire and ground wire to the corresponding terminals and
tighten the screws according to the logo on the power plug.
2. Assemble power terminal.
The power terminals will be installed at the end of the output direction.
Please refer to the picture below to connect live wire and neutral
wire.Tighten the screws with the cross screwdriver, and tighten the power
cable.
Figure 3-7 The Schematic diagram of power plug connection
3. Connect the power cable to PWR interface in the maintenance cavity.
4. The power cable is laid along the pressure clamp, pulling out the
maintenance cavity from the PWR hole.
5. After the cable connection is complete in the maintenance cavity, tighten the
screws on the cover to close the maintenance cavity using
3mm L-shape
allen wrench
.
AC direct supply Mode
The two ends of the power adapter are bare terminals. Install power plugs and
terminals at both ends of the power adapter.
The input of the power adaptor connects to the outlet
.
If the outlet is indoors, place the power adaptor indoors.
If the outlet is outdoors, place the power adaptor in a water proof box.