User's Manual

Lear UGDO
Lear UGDO Owner’s Guide Version 3.2 Page 8 3/27/2006
Erasing Lear UGDO™ Buttons
Note
The system allows for three devices to be programmed. If you need to change or replace any of
the three devices after it has been initially programmed, it will be necessary to erase the current
settings using the “Erasing Lear UDGO™ Buttons” procedure and then reprogram ALL of the
devices being used.
In order to erase either rolling code or fixed code on the LEAR UGDO™ device, use the
following procedure:
1. Firmly PRESS the two outside Lear UGDO™ buttons simultaneously for approximately
twenty seconds until the indicator lights begin to blink rapidly. The indicator lights are
located directly above the buttons.
2. Once the indicator lights begin to blink, RELEASE your fingers from the buttons. The
codes for all buttons (fixed and rolling code) are erased.
FCC and RSS-210 Industry Canada Compliance
If your vehicle is equipped with a Lear Car2U ™ transmitter, it complies with Part 15 of the FCC
Rules. Operation is subject to two following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received including interference that may
cause undesired operation.
The Lear UGDO™ transmitter complies with RSS-210 of Industry Canada. Operation is subject
to the following two conditions:
1. This device may not cause interference
2. This device must accept any interference received including interference that may
cause undesired operation of the device
Changes and modifications to the Lear Car2U ™ transmitter by other than an authorized service
facility could void authorization to use this equipment.
Hold down the two outside
buttons simultaneous for ten
seconds to erase code.
Indicator Lights
Short Term Confidentiality Requested