User's Manual

LEAR Car2U ™
LEAR Car2U ™ Owner’s Guide Version 3.3 Page 6 12/2/2005
5. After inputting the switch settings, simultaneously Press and Release all 3 Car2U buttons.
The indicator lights will turn on.
6. Return to your vehicle, Press and HOLD the Car2U Button you would like to use to
control the garage door. You may need to hold the button from 5 to 55 seconds during
which time the selected button indicator light will blink slowly. Once the garage door
begins to move immediately (within 1 second) release the button. The indicator light will
blink rapidly until programming is complete Press and release the button again. The
garage door should move confirming that programming is successful and complete.
NOTE
Do not release the button until you see the garage door move. Most garage
doors open quickly. However, some garage doors may take from one to two
and a half minutes to open for the initial garage door opener programming.
Press ANY one of the
three LEAR Car2U ™
buttons to assign the
fixed code sequence to
the garage door opener.