User's Manual

LEAR Car2U ™
LEAR Car2U ™ Owner’s Guide Version 3.3 Page 3 12/2/2005
Programming Rolling Code Garage Door Opener or Device
1. Firmly PRESS the outer two LEAR Car2U ™ buttons for one — two seconds and
immediately release them.
2. Go to the garage. Locate the garage door motor head and Press and Release its “learn”
button. You may need a ladder to reach the unit and you may need to remove the unit’s
cover to locate the “learn” button. After pressing the “learn” Button you have 10 to 30
seconds to complete Step 3 depending on your garage control unit If you cannot locate
the “learn” button, refer to the Owner’s Guide of your garage door opener or call 1-866-
57Car2U.
3. Return to your vehicle, Press and HOLD the Car2U Button you would like to use to
control the garage door. You may need to hold the button from 5 to 20 seconds during
which time the selected button indicator light will blink slowly. Once the garage door
begins to move immediately (within 1 second) release the button. The indicator light will
blink rapidly until programming is complete Press and release the button again. The
garage door should move confirming that programming is successful and complete.
Press ANY one of the three
LEAR Car2U ™ buttons to
assign the rolling code to the
garage door opener.
“Learn” Button on the
Garage Door opener
motor head