Instruction Manual

BATTERY INFORMATION

Battery Removal and Installation

1. Make sure the unit is turned Off.

2. Locate the battery cover on the

bottom of the unit, use a coin or

screwdriver to loosen the screw and

open the battery cover.

3. Remove old batteries by pulling up on

one end of each battery.

4. Install 2 new AA (AM-3/LR6) batteries

following the diagram inside the battery

box. (For best performance, alkaline batteries or fully charged

Ni-MH rechargeable batteries are recommended.)

5. Replace the battery cover and tighten the screw to secure.

IMPORTANT: BATTERY INFORMATION

• Insert batteries with the correct polarity (+ and -).

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc) or

rechargeable batteries.

• Only batteries of the same or equivalent type as recommended

are to be used.

• Do not short-circuit the supply terminals.

• Remove batteries during long periods of non-use.

• Remove exhausted batteries from the toy.

• Dispose of batteries safely. Do not dispose of batteries in fire.

RECHARGEABLE BATTERIES

• Remove rechargeable batteries from the toy before charging.

• Rechargeable batteries are only to be charged under

adult supervision.

• Do not charge non-rechargeable batteries.