® Instruction Manual This manual contains important information. Please keep it for future reference. Ce guide contient des informations importantes. Veuillez le conserver pour toute référence future.
INTRODUCTION Thank you for purchasing the LeapStart® interactive learning system. Book Holders Speaker Stylus Volume Control On/Off Button Power Light Interactive Liners Battery Compartment Carrying Handle USB Port Headphone Jack* *Compatible with most headphones. Headphones not included.
INCLUDED IN THE PACKAGE • LeapStart® interactive learning system • USB cable • Activity book (Number of books may vary in different versions.) • Quick Start Guide WARNING All packing materials, including tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety. NOTE Please save this Instruction Manual as it contains important information.
GETTING STARTED • Install 2 AA batteries in your LeapStart® learning system. (See: Battery Information) • Press the On/Off Button to begin. The green Power Light will shine when the LeapStart® system is on. Your LeapStart® system is now ready to be used! Using LeapStart® Books • POWER UP: Turn on the LeapStart® learning system. • SET UP: Snap a LeapStart® book into the Book Holders in your LeapStart® learning system and touch the tip of the Stylus to any image or word.
BATTERY INFORMATION Battery Removal and Installation 1. Make sure the unit is turned Off. 2. Locate the battery cover on the bottom of the unit, use a coin or screwdriver to loosen the screw and open the battery cover. 3. Remove old batteries by pulling up on one end of each battery. 4. Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.) 5.
WARNING: Adult assembly required for battery installation. Keep batteries out of reach of children. ATTENTION : Les piles ou accumulateurs doivent être installés par un adulte. Tenir les piles ou accumulateurs hors de portée des enfants. PRODUCT FEATURES 1. On/Off Button Press the On/Off Button. The LeapStart® learning system will start up and you will hear a welcome message. 2. Stylus Touch the tip of the Stylus to the book to interact with the pages. 3.
• Routinely check this toy for proper and safe condition. If there is any damage or broken parts, remove toy from use. • Long-term exposure to loud sounds, at high volume, may result in permanent hearing loss. When using headphones or ear buds, it is recommended that the product is listened to at lower volumes for shorter periods of time. Set the volume while in a quiet environment; turn the volume down if you cannot hear people speaking near you.
CARE & MAINTENANCE For Indoor, Dry-Location Use Only: Do not use the product near a sink or other wet locations. Take care not to spill food or any kind of liquid on this product as it may render it inoperable and not serviceable. In case the unit does get wet, unplug all cables and turn it Off. Allow to dry thoroughly before reusing. Do not attempt to dry with a hair dryer or other heat source.
TROUBLESHOOTING If for some reason the unit stops working or malfunctions, please follow these steps: 1. Turn the unit Off. 2. Interrupt the power supply by removing the batteries. 3. Let the unit stand for a few minutes, then replace the batteries. 4. Turn the unit On. The unit should now be ready to use again. 5. If the unit still does not work, install a new set of batteries. Environmental Phenomena Static electricity may cause the LeapStart® to malfunction.
Supplier’s Declaration of Conformity 47 CFR § 2.1077 Compliance Information LeapFrog® 6131 LeapStart® LeapFrog Enterprises, Inc. 2200 Powell Street, Suite 500, Emeryville, CA 94608 Website: leapfrog.com/leapfrog.ca THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. USB Cable: Use only the USB cable provided by LeapFrog.
Visit our website for more information about our products, downloads, resources and more. leapfrog.com leapfrog.ca Read our complete warranty and legal policies online at leapfrog.com/legal LeapFrog Enterprises, Inc., A subsidiary of VTech Holdings Limited. TM & © 2021 LeapFrog Enterprises, Inc. All rights reserved.
