0 IM_0427.indd 1 Parent’s Guide This guide contains important information. Please keep it for future reference. Ce guide contient des informations importantes. Veuillez le conserver pour toute référence future.
LeapStart® Features LCD Screen On/Off Button Power Light USB Port 0 IM_0427.indd 2 Headphone Jack* Volume Control *Compatible with most headphones. Headphones not included.
0 IM_0427.
Get Started 1 Power Up Charge your LeapStart® Go system by connecting it to your computer or outlet via the USB cable. Charge for at least one hour for optimal performance. Your LeapStart® Go system is now ready to be used with the included Sampler Book! 2 Set Up Download the LeapFrog® Connect application at leapfrog.com/connect and install it on your computer.
Get Started With Your Sampler Book 1 PRESS the On/Off Button to begin. The green Power Light will shine when the LeapStart® Go system is on. 2 TOUCH the tip of the stylus to any image or word on your Sampler Book. Download Companion Audio and Video for Purchased LeapStart® Books 1 Turn on the LeapStart® system and touch a page. 2 If you have not already done so, follow the instructions under Get Started to install the LeapFrog® Connect application.
Power Light Indication The Power Light on the LeapStart® Go system has different behaviors in the circumstances below: Circumstance System On Charging Status* Charging Status (when connected to LeapFrog® Connect) Charging Complete Charging Complete (when connected to LeapFrog® Connect) Bad Unit Power Light Behavior Green Amber Red and amber flashing in about 1 second intervals Green Green flashing in about 1 second intervals Green, red or amber lights flashing rapidly * If there is an issue charging the b
Instructions opérationnelles A utiliser uniquement en intérieur, dans un endroit sec. Ne pas utiliser le produit près d’un lavabo ou autres sources d’eau. Faites attention à ne pas renverser de nourriture ou tout autre sorte de liquide sur ce produit car cela pourrait le rendre inopérationnel et inutilisable. Si vous renversez du liquide sur le produit, débranchez tous les cisable et éteignez-le. Laissez le produit sécher complètement avant de le réutiliser.
be affected. If you experience ringing in your ears or hear muffled speech, stop listening and have your hearing checked. Note: Maximum output voltage ≤ 150mV Accessories Please read all safety instructions for any accessories or other products before using with the LeapStart® Go system. LeapFrog is not responsible for the operation of third-party accessories or their compliance with safety and regulatory standards.
• Unplug the AC Adapter (transformer) if any of the following conditions exist: - The power cord or plug, or the USB cord has become frayed or damaged. - The power adapter is exposed to rain, liquid, or excessive moisture. - The power adapter enclosure has become damaged. - You suspect the power adapter needs service or repair. • To clean the transformer, disconnect it from the wall and clean with a slightly damp cloth. Do not immerse in water or use soap or other chemicals. Allow to dry before reusing.
Accessoires : Lisez les instructions pour les accessoires ou tout autre produit avant de les utiliser avec le LeapStart® Go. LeapFrog n’est pas responsable pour les accessoires vendus par d’autres fabricants et leurs standards de sécurité. Remplacement des piles ATTENTION : La pile rechargeable lithium ne peut être retirée de ce produit. Pour votre sécurité, n’essayez jamais de retirer la pile.
• Débranchez l’adaptateur si : - Le câble, la prise ou le câble USB est abimé ou cassé. - Le câble, la prise ou le câble USB sont exposés à la pluie, à du liquide ou une humidité excessive. - La boite de protection de l’adaptateur est abimée. - Si vous pensez que l’adaptateur a besoin d’être réparé. ATTENTION : Ne recharger pas des piles non-rechargeables. Câble USB.
FCC Compliance Statement. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. The FCC Compliance Statement is accessible in the LeapStart® Go system. It is shown on the LCD screen by following the steps: 1. Turn on the LeapStart® Go system. 2.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
0 IM_0427.
Visit our website for more information about our products, downloads, resources and more. leapfrog.com Read our complete warranty policy 0 IM_0427.indd 15 online at leapfrog.com/warranty. LeapFrog Enterprises, Inc., a subsidiary of VTech Holdings Limited. TM & © 2019 LeapFrog Enterprises, Inc. All rights reserved. Printed in China.
