User's Manual

a module solution provider
WARNINGS, RESTRICTIONS AND DISCLAIMERS
9. End Product Labeling
When the module is installed in the host device, the FCC/IC ID label must be visible through a window on the final device or it must
be visible when an access panel, door or cover is easily re-moved. If not, a second label must be placed on the outside of the final
device that contains the following text: “Contains FCC ID: QDX31511” “Contains IC: 4810A-31511 “
The grantee's FCC ID/IC ID can be used only when all FCC/IC compliance requirements are met.
10. This device is intended only for OEM integrators under the following conditions:
(1) The antenna must be installed such that 20 cm is maintained between the antenna and users,
(2) The transmitter module may not be co-located with any other transmitter or antenna.
(3) The chip antenna with -2.46 dBi gain was verified in the conformity testing. Radiated transmit power must be equal to or lower
than that specified in the FCC/IC Grant of Equipment Authorization for FCC ID: QDX31511 and IC: 4810A-31511. A separate approval
is required for all other antenna type, or higher gain antenna.
In the event that these conditions cannot be met (for example certain laptop configurations or co-location with another transmitter),
then the FCC/IC authorization is no longer considered valid and the FCC ID/IC ID cannot be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a
separate FCC/IC authorization.