Owner's manual

8
Specications IRB* Replacement
Item Number LT-ELP223Q LT-ELP116Q
1. Unscrew the Front Head Cap
counterclockwise to expose the
IRB*.
2. Pull out IRB* from the Flashlight
Head.
3. Follow the above step in reverse
order to install a new IRB*.
Battery Operating Time 2hrs+ 2hrs+
Bulb Type 23mm LED IRB 16mm LED IRB
Weight with Batteries 4.9 oz 3.1 oz
Voltage 6V 3V
Length 3.38” 3.15”
Max. Lumen 150 lumens 90 lumens
Focus Preset Preset
Battery/Qty CR123A x 2 CR123A x 1
*IRB - Integrated Reector and Bulb
Replacement Parts (Contact your ashlight distributor for the following replacement parts:)
BAT-LIT880 IRB-ELS016 IRB-EL023 IRB-ELS023
2pc Set of CR123A Lithium
Batteries
16mm 5-function LED IRB
for LT-ELP116Q
23mm LED IRB
for LT-ELP223Q
23mm 5-function LED IRB
for LT-ELP223Q
7
Maintenance
1. Maintain the metal surface of the ashlight by removing any dirt or sand with a soft
brush to avoid scratching the nish.
2. Store the ashlight in a cool dry place when not in use. Be careful to avoid contact with
acid, alkaline or corrosive chemicals.
3. Replace the batteries in your ashlight every few months if it was not used for long
period of time. This insures good working batteries for your light and prevents battery
leakage.
4. Keep a fresh package of batteries next to your ashlight. This gives you back-up
power for your light.
5. Do not store your ashlight in high temperatures. This would damage your ashlight
and may result in battery leakage.
6. Do not put the ashlight head against any surface especially paper or human skin for it
has heat and may result in accidents.
7. Do not leave your ashlight under the seat in your car, or in direct sunlight to avoid over-
heating.
8. Do not attempt to lubricate any part of the ashlight.
9. Do not disassemble the ashlight other than replacing light bulb or pressure switch. Do
not loosen or remove screws or parts. Any such or similar actions will void the warranty.
Front Head Cap
LED IRB