User's Manual
Introduction
Thank you for your purchase of the RadioPopper PX wireless radio
system. We hope you’ll nd this system to be a valuable tool in your
creative lighting, giving you exibility and control never before
possible.
The RadioPopper PX system allows you to use the automatic and
high-speed sync functions built into your existing ash units without
concern of whether or not the master and slave units can “see” each
other. You now have the ability to place your lights wherever you
choose, then controlling the output power of each slave ash from the
camera body manually or automatically via your camera’s ETTL or iTTL
logic system. It’s also the world’s rst product to eectively provide
you high speed sync by radio. Enjoy.
Please read this short manual entirely before installing or operating
your RadioPopper PX wireless system. Proper installation is key to
correct operation.
If you have any troubles along the way, feel free to call or email.
How It Works
The RadioPopper PX system is beautifully simple. Quickly mount the
PX Transmitter to your Master ash, a PX Receiver to each slave ash,
and your current master and slave wireless ash system continues to
function just as it always has, minus the line of sight limitation.
The RadioPopper PX Transmitter “listens” to the light signal being
created inside the master ash unit or remote commander on your
camera’s hot shoe. The PX Transmitter sends this signal by radio where
it is read by the RadioPopper PX Receiver. The receiver then uses it’s
own internal light source to “reproduce” this light signal. The light is
emitted through a window on the back of the Receiver unit directly
into the infrared sensor on a slave ash, that slave ash responds to the
“reproduced” light signal just as it normally would had it seen the light
directly from the master ash.
Installation is easy. Just place the RadioPopper PX Transmitter on top
of your master ash or IR commander device using the included Velcro
pads. “Look Ma! No wires!”
On the receiving end, add a PX Receiver in a similar way, anchor the
Receiver in such a way that the window with the green circle is placed
directly over the black window (the IR sensor) of your slave ash. No
wires or adaptors and no complicated system to re-learn.
Now just power up and shoot. You’ve got remote control of your slave
ashes, full ETTL and iTTL support along with high speed sync all the
way to 1/8000, by radio.
RadioPopper PX Radio Wireless System Introduction
Page 4 Page 5