User's Manual

Transmitter Mounting on Other Hardware
For mounting the P1 Transmitter on other hardware such as the Canon ST-E2 and Nikon SU-800 IR Commanders,
the mounting is essentially the same. Mount the P1 Transmitter to the very top of the Master device, about
centered with the magnetic pickup sensor facing forward and the antenna pointed upward.
For additional images of product mounting, please see the Support section of our website.
Canon ST-E2: We suggest mounting Velcro to the front side of the battery cover.
Nikon SU-800: Mount directly on the top edge, which is a bit rounded but with proper placement and pressure
on the Velcro pads, a good anchor should be achievable.
Nikon “Pop-Up Flash”: Your P1 Transmitter was never intended to be used with a Nikon “pop-up ash (used
as a master CLS commander on some camera bodies) but it does work. Though placement is somewhat ‘impro-
vised’, note that you should only mount your P1 transmitter behind the ash with the magenetic pickup sensor
nearest the back side of the ash. You should not mount it in front of the ash where the ash is ring directly
at the unit.
SPEEDLITE
580EX
Transmitter Mounting on Master Flash
Top View (looking down from top)
Transmmitter should be just about centered on
top of the master ash. The pickup sensor should
point forward toward the end of the ash that
emitts light. The rear edge of the Transmitter should
just begin to cover the text printed on the top of
your ash.
Mount in a similar location for all models of Master
ash (Canon 550EX, 580EX, 580EX II, and Nikon
hardware SB-800 and the like).
Installation
Page 13
Fig 2-1
Master Flash Light Output