Owner's Manual

ILIE
~1K 'STEREO 130'
A'- ____________________ I_N_ TE _G_R_A_ TE _D_ AM _ PL _ IF _ IE _R
INSTALLATION OPERATION MAINTENANCE
input
OPT 2 o o COAX
bass
direct treble
SO UR CE RE MOTE BASS DI REC T TR EB LE
IN PUT INPUT CONT ROL BU TTON / L ED CONT RO L
STANDBY MODE
balance
()
Operation
STEREO 130
volume
BAlANCE HEADPH ON E VOLUM E POWER S TA NDBY
CONT R OL O UT PUT CONT R OL LED BUTTON
The LEAK STEREO 130 will be in standby mode when powered on. Power LED indicator on fron t panel will show dark red. Press the Standby bu tt on or the
(!) button on the remote handset to bring LEAK STEREO l 30 out of standby.
You can ac tivate the 'auto standby' function by pressing and holding the Standby button on the fron t panel until t he LED blinks. A short press of the Standby
button
then selects the Auto - Standby function as follows:
20 min Auto-Standby
The Power LED indicator flashes twice: Auto-Standby 20 minutes. LEAK STEREO 130 will automatically go into Standby mode ii there is no signal input or
operation for
20 minu tes.
l Hour Auto-Standby
The Power LED indicator flashes thrice: Auto-Standby l hour . LEAK STEREO l 30 wi ll automatically go into Standby mode ii there is no signal input or
operation for l hour.
Never
Au to-Standby (Defa ul t)
The Power LED indicator flashes once: Auto-Standby Never. LEAK STEREO 130 will not go into Standby mode.
VOLUME CONTROL
Alter turning on, the LEAK STEREO 130 vol ume knob wi ll automatically rotate to reduce t he volume, and then stop for a few seconds.
You can adjust the volume knob on the front panel or press the volume button of the remote control to adjust the volume level as needed.
Press the MUTE button on the remote control to enter MUTE mode. Note: the se lected input indicator fl ashes to show t he amplifier is in MUTE mode.
PLAYING MUSIC VIA ANALOG INPUTS
Connect the analog signal of a source unit to LEAK STEREO l 30 's AUX l or AUX2 input. Rotate the INPUT selector on the front panel (or press the INPUT select
key on
the remote control) to select the AUXl or AUX2 input indicator will light and music will start playing.
PLAYING MUSIC VIA DIGITAL INPUTS
Connect the coaxial SPDIF signal of source un it s to the digital in COAX jack or the optical (TOSlink) signal of source u nits to the OPTl or OPT2 jack on the
LEAK STEREO l 30 's rear panel. Rotate t he INPUT selector on the front panel (or press the INPUT select key on the remote control) to select the
COAX/OPTl /OPT2 LEAK Stereo 130 inpu t, t he selected input indicator will light and music will start playing.
Page
11