Technical Specs
Table Of Contents
- User manual_rev01
- Contents
- Change History
- Table
- Figure
- 1 Introduction
- 2 Technical Specification
- Description
- Items
- 23 ± 0.3 mm
- Length
- 10.2 ± 0.3 mm
- Width
- 2.65 ± 0.3 mm
- Height
- 1.8 g
- Weight
- Description
- Item
- -30 deg. C to +75 deg. C
- Operating temperature range
- -35 deg. C to +75 deg. C
- Storage temperature range
- Up to 95% non-condensing or a wet
- Humidity
- Bulb temperature of +35 deg. C
- 3 Appendix
- 4 Federal Communications Commission (FCC) Statement
- OEM Guidance
© 2016 Leadtek Research Inc. All rights reserved. LEADTEK Confidential Page : 5 / 12
Preliminary Confidential - Information is subject to change without prior notice.
1.1.2 Hardware and Software
• Support for concurrent multi-protocol
• 12-bit, 200 ksps ADC - 8 configurable channels with programmable gain
• 64 level comparator
• 15 level low power comparator with wakeup from System OFF mode
• General purpose I/O pins
• Digital microphone interface (PDM)
• 5x 32-bit timers with counter mode
• Up to SPI master/slave with EasyDMA
• Up to I2C compatible 2-Wire master/slave
• UART (CTS/RTS) with EasyDMA
• Programmable peripheral interconnect (PPI)
• AES HW encryption with EasyDMA
1.2 Advantages
• 2.4 GHz transceiver
• -96 dBm sensitivity in
Bluetooth
®
low energy mode
• 1 Mbps, 2 Mbps supported data rates
Flexible power management
• Supply voltage range 2.6 V–3.6 V
• Fully automatic LDO and DC/DC regulator system
• Serial wire debug (SWD)
1.3 Block Diagram
Figure 1-2： LR BT01 Block Diagram