Technical Specs

Preliminary Confidential - Information is subject to change without prior notice.

4 Federal Communications Commission (FCC) Statement

You are cautioned that changes or modifications not expressly approved by the part responsible for

compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1) this device may not cause harmful interference, and

2) this device must accept any interference received, including interference that may cause undesired

operation of the device.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

FCC RF Radiation Exposure Statement:

The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment

and are safe for intended operation as described in this manual. The further RF exposure reduction can

be achieved if the product can be kept as far as possible from the user body or set the device to lower

output power if such function is available.

The final end product must be labeled in a visible area with the following: “Contains Transmitter Module

FCC ID: I2ILRBT01,””.

This module has been granted modular approval for mobile applications. OEM integrators for host

products may use the module in their final products without additional FCC certification if they meet the

following conditions. Otherwise, additional FCC approvals must be obtained.

The host product with the module installed must be evaluated for simultaneous transmission

requirements.

The users manual for the host product must clearly indicate the operating requirements and conditions

that must be observed to ensure compliance with current FCC RF exposure guidelines.

To comply with FCC regulations limiting both maximum RF output power and human exposure to RF

radiation, the maximum antenna gain including cable loss in a mobile-only exposure condition must not

exceed {Insert Reference to Your Antenna Information Here}.