User's Manual

3332
IN THE BOX
Optional Accessories
Accessories
Cradle with Cigarette
Lighter Charger
AC Adapter
USB Cable
Carrying Case
Wiping Cloth
Quick Reference
Guide
1200mAh Battery
Dummy SD Card (Inside Main Unit)
Registration Card
Owner’s Manual
The following accessories are available from your authorized Alpine dealer.
1. PMD-DOK1 A Docking Station that allows you to connect and experience
Blackbird navigation and music player from your Alpine Multimedia Station or
stand-alone display.
2. PMD-KIT1 A second car kit comprised of windshield mount, cradle, and
home AC charger.
3. PMD-ANT1 An external GPS antenna hard-wired to Blackbird used in
instances where you cannot normally receive GPS signals inside the car, due
to metallic window tint, etc.
4. PMD-BAT1 A 1200 mAh Li-Polymer battery for extra battery power on the go.
5. RUE-4140 A combination navigation and audio remote control that allows
you to control most of Blackbird’s navigation features wirelessly.
IN CASE OF DIFFICULTY
If you encounter a problem, please review the items in the following check-
list. This guide will help you isolate the problem if the unit is at fault.
Otherwise make sure the rest of your system is properly connected, batteries
are completely charged and contact your authorized Alpine dealer or Alpine
directly at 1-888-NAV-HELP (1-888-628-4357).
The vehicle’s position is erroneous.
Drive the vehicle in an area of good GPS reception to allow the unit to recali-
brate itself.
Move to a location where strong GPS reception is possible.
No operation
· Moisture condensation
Allow enough time for the condensation to
evaporate (about 1 hour).
· Ambient temperature
Lower the temperature in the vehicle to
over 122°F (50°C) below 122°F (50°C) by driving with the win-
dows open or air conditioner on.
· Blown fuse
Replace with a fuse of the prescribed rating
(2A glass-type fuse located in the head of the
cigarette lighter adapter).
The monitor display is off-center.
Go to
Main Menu
Setup
Display Adjustment
Battery Installation
Place Blackbird face down on a flat surface.
Press the battery door and pull away from
the main unit body.
Attach the battery to the battery door will
be a click sound-heard.
Insert and slide the battery assembly back
into the main unit until a click sound
is heard.
2
3
4
1
Always turn off power to the system before
installing or removing the battery. Failure to do
so will result in damage to your system.
WARNING