User's Manual

Nozzle Direction

Density Dynamic SN

Purge Print Information

Adv. Setting Home

OK Cancel

Purge Test

OK Cancel

Purge Test

Printhead Printing Test

Use the PURGE PRINT setting to test the printer.

Touch the icon to start at this setting.

Hold the active button while rolling the printer to print

information of test.

Then position the printer flush against the print surface

and scroll normally to test the printer. At first the printer

will release a small amount of ink to clean the printhead

before continuing to print the test pattern. When the test

is completed the printer will beep.

Please check the print results.

If the printing test results in horizontal or vertical

bending, please repeat the printhead printing test.

(Please see P39. Cleaning the Printhead)

If the test results do not improve, then there may be blockage in the printhead or scratches on the printhead

surface. If required, please replace the ink cartridge, replace the rechargeable batteries, or recharge the

batteries.

Please install a new ink cartridge.

(Please see P8. Ink Cartridge Installation)

When the test is finish, touch the OK key or Cancel key

to return to the main screen.

0123456789