User's Manual

Printhead Printing Test

Use the PURGE PRINT setting to test the printer.

To perform a printhead test using all nozzles, select

PURGE PRINT (“P”) in settings configuration mode.

To confirm, press the confirmation key. Then position

the printer flush against the print surface and scroll

normally to test the printer. At first the printer will

release a small amount of ink to clean the printhead

before continuing to print the test pattern. When the

test is completed the printer will beep.

M o d e

PURGE

P R I NT

Please check the print results.

If the printing test results in horizontal or vertical

bending, please repeat the printhead printing test.

(Please see P39. Cleaning the Printhead)

If the test results do not improve, then there may be blockage in the printhead or scratches on the printhead

surface. If required, please replace the ink cartridge, replace the rechargeable batteries, or recharge the

batteries.

Please install a new ink cartridge.

(Please see P8. Ink Cartridge Installation)

0123456789