User's Manual

Function Items Description
Configuring Active Nozzles
The nozzles in use can be configured based on your printing needs.
Use of different nozzle modes will result in different print results.
Both
Configure the printer to use all
nozzles
Even
Configure the printer to use only
even nozzles
1
2
Press the function to enter settings configuration mode.
Use the selection keys to select “H” or ACTIVE NOZZLE
mode, then press the confirmation key.
Use the selection keys to switch between the three firing
modes, then use the confirmation key to save your selection.
M o d e
A C T IVE
N OZZLE
3
Once one of the three modes has been selected, press the
confirmation key to save all changes. Once the mode is
successfully changed, the printer will beep.
M o d e
E ven
M o d e
Both
Odd
Configure the printer to use only
odd nozzles
Using “both” will result in darker print results.
If the printing surface is rough, “both” mode may result in undesirable print results. For uneven surfaces, use
of “even” or “odd” modes is recommended.
Print density will affect the printing results in these three modes. Please see the next page for more information
about print density.
It is recommended not to use “both” mode for fine printing (e.g. detailed images, barcodes, QR codes).
34
Warning