User's Manual

Once the printer is correctly aligned and flush with the print surface, hold down the active button.

When the active button is held down, the RUN LED will light up. The mode indicator panel and LCD preview will

turn off. Then the printer will beep indicating that it is ready to print.

While holding the active button, move the printer until the message is printed completely.

After the message has been printed, the printer will beep again. At this point, release the active button. The RUN

LED will turn off, the mode indicator panel and LCD preview will turn on.

‧If the active button is released prematurely during printing, the printer will detect an error. It will beep three

　times indicating that the printing was interrupted.

‧Please roll the printer at a reasonable and consistent speed. There may be a degradation of quality if the

　printer is moving too quickly, slowly, or if there is a large change in rolling speed.

‧The specific speed that the printer must be rolled at depends on print density.

　If print density is set to "1": the printer should be rolled at about 30m/1min.

　If print density is set to "2": the printer should be rolled at about 15m/1min.

　(Please refer P35. Configuring Print Density)

RUN ERR INK BAT PWR

Warning

Please use the printhead cap after printer usage. The

cap protects the inkjet head from foreign materials as

well as drying.