User manual

ManualsBrandsLDT LITTFINSKI DATEN TECHNIK ManualsModel Train ElectronicsLight-DEC-Basis-B

Layout-Light-Control Light-DEC – Manual

- 13 -

By calling the menu Start properties there will be always at first the property

indicated which is presently active. Ex-factory this will be “Always active”.

With the keys ABOVE or BELOW is it possible to

select the Start property between >DCC-

Address<, >Button/Switch< and >Always

active<:

6.1.1. Start/stop of Light-DEC via external push buttons/switches

If you want to start or stop the Light-control Light-DEC manually via one of the 8

push buttons or switches which can be connected to the Basic-Module you can

assign the external push button by depressing the key RIGHT when the display

indicates >Ext. Button:<.

If there was previously no external push button

assigned e.g. after first putting into operation the

display will indicate this with the sign “-“.

If there was already a push button assigned this will be indicated at the display.

Switch now the push button or switch for the start and stop of the Light-control

Light-DEC on and off. At the display will be the number of the push button or

switch indicated.

The previous defined push buttons or switch

numbers will be indicated.

Activating this button will start the Light-control with the adjusted start time and

will stop when activating the button again.

If you want to use this function for a switch the Light-control will start by switching-

on the switch. If the switch will be switched-off the Light-control will stop.

6.1.2. Start/stop of Light-DEC via DCC-Addresses

If you want to start and stop the Light-control Light-DEC digital via a DCC-address

you can program the DCC-address by depressing the key RIGHT when the display

indicates >DCC-Address<.

If there was previously no DCC-address

programmed e.g. after the first putting into

operation the display will indicate this with the sign

“----“.

If there was already a DCC-address programmed this will be indicated at the

display. Send now the DCC-address from your digital central unit or your model

railway control software, which are assigned for the start and stop of the Light-

control Light-DEC. It has to be an accessory address, which will be e.g. used as

well for the switching of turnouts.

If the Basic-Module recognizes the DCC-address this will be indicated at the

display.

Start property

Button/Switch

Start property

DCC

Address:

----

Start property

Ext. Button:

Waiting for

Ext. Button: 2