User manual

HSI-88-USB – Manual
- 5 -
8. Select now again the correct driver for your Windows operating system (the
example is Windows XP) (image left). The second driver will now be copied from the
CD to your PC (image right).
9. Click now again on “Fertig stellen” (“Complete”) (image left). The PC reports now
that the new hardware has been installed and can be used (image right).
10. The installation of the USB-Drivers has now been completed. Now you can
remove the CD “USB-Drivers for DiCoStation and HSI-88-USB“ from the disk drive.
If it is not possible, to install the appropriate USB drivers, you can ask Mr. Falkner,
our programmer of the USB driver, for help with the installation. You can reach Mr.
Falkner by phone always on Monday from 19:00 to 21:00 clock under 0160 96 32 84
62. Or you can write him an e-mail for help ([e-mail]).