Specifications

Document is the property of LDL-Technology and cannot be
reproduced or transmitted without written consent
WUS MOTO Gen3 8,5mm
Rim Hole Mounting
process
Ref : C 318 072 0000
Version : A1
¨ The valve cap must always be in place (except for inflating, pressure release or pressure
checks).
5.2. WUS MOUNTING
¨ Check the external surface of the rim cleanness ; remove grits and other paint marks
¨ Orientation of the Wheel Unit Sensor on the rim: the WUS Case laser marked must be visible
after mounting.
¨ The L Valve should be oriented right side of the motorbike to authorize an easy inflating when
motorbike is on park stand.
¨ Shove the valve into the valve hole, the seal must face the rim.
¨ Maintain the valve and push onto the WUS Case when the keying with the valve is aligned
(90°between housing and Valve).
¨ While screwing keep the WUS Case in place.
NOTA : For LSV type mounting, use a 11mm flat wrench to maintain the LSV during the screwing
process.
C318-072-0000-A2-WUS Moto Gen3 8.5 Mounting Specification.odt LDL Technology SAS
8/ 20 France
Copyrights 2019
Step 2
Align the keying
between valve
and housing
Right Side
Left Side
Step1
Insert and
maintain the valve
Step 3
Push the WUS Case
Step 4
Torque the T15 Screw