Specifications

Document is the property of LDL-Technology and cannot be
reproduced or transmitted without written consent
WUS MOTO Gen3 8,5mm
Rim Hole Mounting
process
Ref : C 318 072 0000
Version : A1
8. WUS DISMOUNTING
It is MANDATORY to interchange the seal if a complete disassembly of the WUS is done (if you
change the rim for example), all unscrewing action on the T15 Screw is equivalent to a
complete disassembly.
It is recommended to interchange the screw if a complete disassembly of the WUS is done (if
you change the rim for example). In this case you use a new thread lock for a better fixation.
8.1. REPLACING VALVE SEAL
For the used valve seal dismounting, use a PLASTIC TOOL to disengage the seal from its case (in order to
avoid damaging the valve).
NEW VALVE SEAL MOUNTING
¨ Do not use lubricant, solvent, grease or oil.
¨ Check that the valve can be used again (no impact, no bending).
To mount the new seal proceed in the reverse direction of the removing
NOTA : Use the same process for the LSV type
C318-072-0000-A2-WUS Moto Gen3 8.5 Mounting Specification.odt LDL Technology SAS
19/ 20 France
Copyrights 2019
Disengage the seal
from its groove
Slide the seal along
the valve body
Remove the used
seal
IT IS MANDATORY TO CHANGE THE
VALVE IF THERE IS ANY SCRATCH
OR HIT INSIDE THREAD
Inside thread