Specifications

Document is the property of LDL-Technology and cannot be
reproduced or transmitted without written consent
WUS MOTO Gen3 8,5mm
Rim Hole Mounting
process
Ref : C 318 072 0000
Version : A1
5.5. METHOD TO VERIFY THE SCREWING TORQUE
¨ The measurement of the residual torque is done by retightening the valve screw by a ¼ turn
maximum in reduced speed (1/4 of a turn in 10 seconds). Therefore use a torque-controlled tool
which is able to memorize the maximum torque. IF the torque mandatory to start the rotation of
the screw in the measurement is equal to 2,1 Nm, stop the procedure, the Torque is correct.
¨ The retightening torque may not be smaller than 2 Nm.
¨ It is recommended to verify the screwing torque at each tire mounting.
C318-072-0000-A2-WUS Moto Gen3 8.5 Mounting Specification.odt LDL Technology SAS
12/ 20 France
Copyrights 2019
Step N°5
- Check that the external part
of the valve does not meet
any obstacle during rim
rotation (like break system).
- Check that the external
seal is correctly set and that
the valve is in contact with
the rim.