Specifications

Document is the property of LDL-Technology and cannot be
reproduced or transmitted without written consent
WUS MOTO Gen3 8,5mm
Rim Hole Mounting
process
Ref : C 318 072 0000
Version : A1
C318-072-0000-A2-WUS Moto Gen3 8.5 Mounting Specification.odt LDL Technology SAS
11/ 20 France
Copyrights 2019
Maintain the WUS Case
and push on the valve
(schema page 7).
AVOID ANY SCREWING IF PLASTIC HOUSING
IS IN CONTACT WITH THE RIM EXCEPT IN THE VALVE HOLE
(the introduction of feeler gauge 0,2mm between the rim and the plastic
parts make you sure that there is no contact).
Step N°4
Step N°3
- Torque the T15 Srew with a
torque screwdriver (T15). Do note
exceed 2 turns per second.
- Final torque 2,1 Nm +/- 0,1 Nm.
*Maintain WUS Case during
screwing