Specifications

Document is the property of LDL-Technology and cannot be
reproduced or transmitted without written consent
WUS MOTO Gen3 HD
Mounting process
Ref : C 317 109 0000
Version : A1
¨ The valve cap must always be in place (except for inflating, pressure release or pressure
checks).
5.2. WUS MOUNTING
¨ Check the external surface of the rim cleanness ; remove grits and other paint marks
¨ Orientation of the Wheel Unit Sensor on the rim: the WUS Case laser marked must be visible
after mounting. Always use specific HD rims with pocket to receive the HD WUS case.
¨ The L Valve should be oriented right side of the motorbike to authorize an easy inflating when
motorbike is on park stand.
¨ Shove the valve into the valve hole, the seal must face the rim.
¨ Maintain the WUS Case and push onto the valve when the keying with the valve is aligned
(90°between housing and Valve).
¨ While screwing keep the WUS Case in place.
C317-109-0000-A1-WUS Gen3 HD Mounting Specification.odt LDL Technology SAS
7/ 19 France
Copyrights 2019
Step 2
Align the keying
Right Side
Left Side
Step1
Maintain
WUS Case
Step 3
Push the Valve
Step 4
Torque the T15 Screw