Specifications

Document is the property of LDL-Technology and cannot be

reproduced or transmitted without written consent

WUS MOTO Gen3 HD

Mounting process

Ref : C 317 109 0000

Version : A1

4.1. SPECIFICATIONS

Screwing torque for valve core mechanism: 0.3 +/- 0.1 Nm.

Screwing torque for valve cap: 0.2 to 0.35 Nm.

Manual screwing torque for T15 Screw: 2,1Nm +/- 0.1 Nm.

Operating Relative Pressure Range: 0 to 3,5 bars.

Relative Maximum pressure range non destructive: 0 to 10 bars

Compatible Inflating Fluid: Air or Nitrogen

Anti-puncture Fluid utilisation: Utilisation without any consequence.

Just introduce Fluid when the valve

is down, close to the ground

Maximum speed of the vehicle: 250 Km/h on rim 17”

********************************************************************************************************************

NOTA :

5. WUS MOUNTING

5.1. PRECAUTIONS DURING MOUNTING OPERATION

¨ Do NOT use WUS after a drop of more than 1 meter on a hard ground

¨ Do NOT generate an electrostatic discharge higher than 6 Kilovolts by air onto the WUS, during

mounting and disassembly of the WUS or at any time during utilization (avoid the use of nylon

worksuit, and in general way, avoid all textile rubbing before handling WUS)

¨ Do NOT store WUS at temperatures higher than 30°C and lower than 0°C

¨ When removing the core from the valve, it has to be replaced by a new chromed short core

(brass without chrome is forbidden) of the same type, according to V0.07.1 ETRTO core

chamber specification.

C317-109-0000-A1-WUS Gen3 HD Mounting Specification.odt LDL Technology SAS

6/ 19 France