Specifications

Document is the property of LDL-Technology and cannot be
reproduced or transmitted without written consent
WUS MOTO Gen3 HD
Mounting process
Ref : C 317 109 0000
Version : A1
8. WUS DISMOUNTING
It is MANDATORY to interchange the seal if a complete disassembly of the WUS is done (if you
change the rim for example), all unscrewing action on the T15 Screw is equivalent to a
complete disassembly.
8.1. REPLACING VALVE SEAL
For the used valve seal dismounting, use a PLASTIC TOOL to disengage the seal from its case (in order to
avoid damaging the valve).
NEW VALVE SEAL MOUNTING
¨ Do not use lubricant, solvent, grease or oil.
¨ Check that the valve can be used again (no impact, no bending).
C317-109-0000-A1-WUS Gen3 HD Mounting Specification.odt LDL Technology SAS
18/ 19 France
Copyrights 2019
Disengage the seal
from its groove
Slide the seal along
the valve body
Check that the seal is
in its lower position
Shove the seal
into the valve
Remove the used
seal
IT IS MANDATORY TO CHANGE THE
VALVE IF THERE IS ANY SCRATCH
OR HIT IN THIS AREA
Inside thread
Present the seal