Specifications

Document is the property of LDL-Technology and cannot be
reproduced or transmitted without written consent
WUS MOTO Gen3 HD
Mounting process
Ref : C 317 109 0000
Version : A1
C317-109-0000-A1-WUS Gen3 HD Mounting Specification.odt LDL Technology SAS
10/ 19 France
Copyrights 2019
Maintain the WUS Case
and push on the valve
(schema page 7).
AVOID ANY SCREWING IF PLASTIC HOUSING
IS IN CONTACT WITH THE RIM EXCEPT IN THE VALVE HOLE
(the introduction of feeler gauge 0,2mm between the rim and the plastic
parts make you sure that there is no contact).
Step N°4
Step N°3
- Torque the T15 Srew with a
torque screwdriver (T15). Do note
exceed 2 rounds per second.
- Final torque 2,1 Nm +/- 0,1 Nm.
*Maintain WUS Case during
screwing