User's Manual

Document is the property of LDL-Technology and cannot be
reproduced or transmitted without written consent
WUS MOTO Mounting process mode
Ref : C 307 020 0010
Version : E2
5.3. WUS SCREWING RECOMMENDATIONS
Make sure the following recommendations are respected :
Screwing speed : max of 2 turns in 1 second.
¨ Apply a torque of 5 Nm +/- 0,5 Nm with the good screwing speed. This is the screwing condition
of on which the specification of our WUS is based.
¨ For the manual process please use a torque controlled tool.
¨ The valve and the nut have to be screwed on 5 complete threads (5 nut rounds) Minimum,
The plastic part must slightly be able to turn around its nut after tightening; under no circumstances it
has to be in contact on the rim surface. You must be able to introduce a piece of paper between the
sensor and the rim (minimum slack of 1/10 mm).
Once mounted, the WUS must be distant from the rim as illustrated here under ; the distance between
them can reach 10mm.
Optimal distance is 1mm.
C3070200010-E2-WUS Mounting process mode.odt LDL Technology SAS
8/ 24 Toulouse – France
Copyrights 2016
From 1/10 to
10 mm