User's Manual

Document is the property of LDL-Technology and cannot be
reproduced or transmitted without written consent
WUS MOTO Mounting process mode
Ref : C 307 020 0010
Version : E2
4.1. SPECIFICATIONS
Screwing torque for valve core mechanism: 0.3 +/- 0.1 Nm.
Screwing torque for valve cap: 0.2 to 0.35 Nm.
Manual screwing torque for nut: 5 Nm +/- 0.5 Nm.
Environmental Temperature Range: -20°C to +60°C.
Monitoring Temperature Range: -30°C to +125°C
Surviving Temperature Range 1 minute : -40°C to +150°C
Relative Pressure Range Monitored: 0 to 3,5 bars.
Relative Maximum pressure range non destructive: 0 to 15 bars
Used Inflating Fluid: Air or Nitrogen
Anti-puncture Fluid utilisation: Utilisation without any consequence.
Just introduce Fluid when the valve
is down, close to the ground
Maximum speed of the vehicle: 350 Km/h on rim 17”
********************************************************************************************************************
NOTA :
5. WUS MOUNTING
5.1. PRECAUTIONS DURING MOUNTING OPERATION
¨ Do NOT use WUS after a drop of more than 1 meter on a hard ground
C3070200010-E2-WUS Mounting process mode.odt LDL Technology SAS
6/ 24 Toulouse – France
Copyrights 2016
This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause
undesired operation of the device
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
1) l'appareil ne doit pas produire de brouillage; 2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.”