User's Manual

Document is the property of LDL-Technology and cannot be
reproduced or transmitted without written consent
WUS MOTO Mounting process mode
Ref : C 307 020 0010
Version : E2
8. WUS DISMOUNTING
It is MANDATORY to interchange the seal if a complete disassembly of the WUS is done (if you
change the rim for example), all unscrewing action on the nut is equivalent to a complete
disassembly. It’s RECOMMANDED to check the screwing torque at each time the tire is
dismounted
8.1. REPLACING VALVE SEAL
For the used valve seal dismounting, use a PLASTIC TOOL to disengage the seal from its case (in order to
avoid damaging the valve).
NEW VALVE SEAL MOUNTING
¨ Do not use lubricant, solvent, grease or oil.
¨ Check that the valve can be used again.
¨
C3070200010-E2-WUS Mounting process mode.odt LDL Technology SAS
18/ 24 Toulouse – France
Copyrights 2016
Disengage the seal
from its case
Slide the seal along
the valve body
IT IS MANDATORY TO CHANGE THE
VALVE IF THERE IS ANY SCRATCH
OR HIT IN THIS AREA
Check that the seal is
in its lower position
Shove the seal
into the valve
Present the seal in this
way, flat surface oriented
to the valve cap
THREADING
Remove the used
seal