User's Manual

Document is the property of LDL-Technology and cannot be
reproduced or transmitted without written consent
WUS MOTO Mounting process mode
Ref : C 307 020 0010
Version : E2
5.5. METHOD TO VERIFY THE SCREWING TORQUE
C3070200010-E2-WUS Mounting process mode.odt LDL Technology SAS
11/ 24 Toulouse – France
Copyrights 2016
Step N°6
- Check that the external part
of the valve does not meet
any obstacle during rim
rotation (like break system).
- Check that the external
seal is correctly set and that
the valve is in contact with
the rim.
Step N°7
- The flat surface of the valve
must feet the flat surface of
rim valve hole.
- The plastic parts must be
free from rim constraints (no
contact).
- The plastic parts must
slightly be able to turn
around its nut,on
approximatively +/- 5°. (no
constraints on plastic parts
operated by the rim sides
after tightening).